To find out more just contact Graitec on (023) 8086 8947 or click on the button below.Adjust how framing element geometry justifies and offsets from one another.īeam cutback is the visible representative gap in beam geometry at the connection point in join relationships. If you haven’t already, don’t forget to download the Graitec Advance PowerPack for Autodesk Revit which helps to increase productivity and improve BIM workflows with over 40 new tools. Visit our Structural engineering software page to explore other Structural design and analysis solutions from Graitec and Autodesk. If you want to copy the haunch or mirror it across to the other side, make sure you also select the reference planes even though the planes are 3d with indefinite limits, it will not copy the cut information and you will need to recut the haunch if you have not copied the reference planes as well. Also notice that Revit has kept the analytical model intact which means it will work if you export it for analysis. Once the cutting is done we can reposition the Lower beam to create the haunch, the reference planes will still cut the elements on moving. Remembering to select the beam or element you want to cut first then the reference plane, also make sure you click on the side of the element you want to keep!!! Next on the Modify Ribbon, Geometry Tab select the cut tool. If you want to make this fully parametric, use the align tool and lock them in place in case anything changes i.e. We now need some reference planes, one that runs vertically up the inside of the column and a sloping one following the lower edge of the beam. Next extend the members using the grips so that we have a clear section to cut. I’ll talk you though creating a structural steel haunch.įirst place your beams as shown above, the haunch only needs to be attached to the column and beam, we will refine the positioning later.

Reference plans can be used to cut the members.

The solution is a lot easier than you think.

I’ve seen people try to fix this by creating model in=place element to either replace or try and cut with voids. So you are working in Revit and placing structural beams and columns, the problem is you need the end of the beam cutting at an angle, but there is no option for this in the properties.

Structural framing revit